 |
 |
 |
 |
Satco 9710 25T5/LED/46-840/DR Safety Coated T5 LED - 25 Watt T-5 Safety Coated Shatterproof LED Replacement for F54 T-5 High Output Fluorescent Bulbs 3200 Lumens, 4000 Kelvin Color Temperature 82 CRI, G5 Miniature Bi-Pin Base. Direct Replacement - for use on Electronic Instant Start and Rapid Start ballasts with no rewiring required (Operates on T-5 Ballasts only, Non-dimmable) Up to 50,000 Hour Life. 10 Bulbs Per Case (case quantities only, price is per bulb). Lamp comes with Manufacturer's 5 year limited warranty. USDA and FDA Approved. Complies with FDA CFR Food Code: Chapter 6 Section 202-11. Meets ANSI 17.1 Elevator Code!
Demonstrating Shatterproof Light Bulbs
Watch Our Television Commercial Here!
- Satco 9710 25T5/LED/46-840/DR Safety Coated T5 LED - 25 Watt T-5 Safety Coated Shatterproof LED Replacement for F54 T-5 High Output Fluorescent Bulbs 3200 Lumens, 4000 Kelvin Color Temperature 82 CRI, G5 Miniature Bi-Pin Base. Direct Replacement - for use on Electronic Instant Start and Rapid Start ballasts with no rewiring required (Operates on T-5 Ballasts only, Non-dimmable) Up to 50,000 Hour Life. 10 Bulbs Per Case (case quantities only, price is per bulb). Lamp comes with Manufacturer's 5 year limited warranty. USDA and FDA Approved. Complies with FDA CFR Food Code: Chapter 6 Section 202-11. Meets ANSI 17.1 Elevator Code!
Satco 9710 25T5/LED/46-840/DR Safety Coated T5 LED - Are coated using the GSS Proprietary Diamond Guard "FEP" process. The coating is guaranteed by the manufacturer of the coating process for the rated life of the fluorescent lamp. This coating will withstand both the heat of the lamp and UV. This high mechanical strength safety coating will reduce the light output of the lamps by less than 1% and is a minimum of 10 mils thick. If the coating should turn yellow, crack or otherwise fail before the end of the rated life of the lamp, GSS will refund the full purchase price as shown on the invoice subject to these conditions: The lamps may be used in open or closed vapor tight fixtures, the lamps must be used in ambient temperatures below 400 degrees Fahrenheit. The lamps must not be used with defective ballasts, fixtures or wiring. The lamps must be used with lampholders that provide adequate contact and proper ballast types. If the lamps are used with motion sensor systems with a time interval of 20 minutes or greater. GSS reserves the right to inspect the site where a lamp safety coating failed.
|
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Features
- Satco 9710 25T5/LED/46-840/DR Safety Coated T5 LED - 25 Watt T-5 Safety Coated Shatterproof LED Replacement for F54 T-5 High Output Fluorescent Bulbs 3200 Lumens, 4000 Kelvin Color Temperature 82 CRI, G5 Miniature Bi-Pin Base. Direct Replacement - for use on Electronic Instant Start and Rapid Start ballasts with no rewiring required (Operates on T-5 Ballasts only, Non-dimmable) Up to 50,000 Hour Life. 10 Bulbs Per Case (case quantities only, price is per bulb). Lamp comes with Manufacturer's 5 year limited warranty. USDA and FDA Approved. Complies with FDA CFR Food Code: Chapter 6 Section 202-11. Meets ANSI 17.1 Elevator Code!
|
|
 |
 |
 |
 |
|
 |

Accessories for this product... |
|
|

|